Put the glue filled syringe into the needle holder and fix it. For example, A glue and B glue are received from the pressure bucket to the glue gun A and the B inlet, and the A and B glue are mixed through three to the mixing tube respectively. The mixing degree of the glue is determined by the length of the mixing pipe. The glue is controlled by the pressure bar only. A series of left and right rotating blades are arranged in the casing, A and B glue. When water passes through the mixing pipe, it is continuously cut and coincident to form a uniform mixture to ensure the exact amount of glue.
Connect the air valve to connect the nozzle of the glue dispenser to the barrel through the trachea, and connect the pin valve to the AIRIN of the dot glue controller, and connect the cable of the dispenser and the dot glue controller.
Connect the spot glue interface through the cable to the signal input interface of the dot glue controller, and connect the foot pedal to the running interface of the glue dispenser to control the running of the glue dispenser. Connect the connecting cable plug of the Z shaft to the Z axis of the dispenser. If the glue controller is the same as the connector model of the glue dispenser, it can be seen according to the different core number of the connector to see the joint of the glue dispensing and operation of the glue dispenser, two core glue and three core running.
The hand-held programmer is selected through the serial port line to the interface on the left of the glue dispenser. If the glue controller is different from the connector on the back of the glue dispenser, the cable can be made up and connected according to the instructions of the dot glue controller.